Sliding And Tilting Mechanism, Removing And Installing, A6: Removing

-- Remove the sunroof shade. Refer to FRONT SUNROOF SHADE, REMOVING AND INSTALLING, A6 .

-- Remove the wind deflector. Refer to WIND DEFLECTOR, REMOVING AND INSTALLING, A6 .

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the headliner and place on the seats. Refer to HEADLINER, REMOVING AND INSTALLING .

-- Cut through the inner side adhesive bead.

• A6 Sedan. Refer to Inner Side Adhesive Bead, Cutting: .
• A6 Sedan, Market-Specific Version, Panorama Roof. Refer to the appropriate service information .
• A6 Avant. Refer to Outer Rear/Right/Front/Left Adhesive Beads and Inner Side/Rear Side Adhesive Beads, Cutting .

-- Lift up the rear sliding and tilting mechanism -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2-.

-- Remove the tilting lever -1- toward the rear.

-- Release the retainer -3- and remove the outer bracket -4- slightly.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainer -2- and remove the inner bracket -1- slightly.

-- Remove the sliding and tilting mechanism -2- up to dimension -a- toward the rear from the brackets -1- in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = approximately 24 mm

-- Pivot the glass panel tilting rail -2- upward in direction of -arrow- until it is disengaged from the driver -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Slide the glass panel tilting rail slightly forward and guide out of the brackets -1-.

-- Push the operating lever -4- slightly toward the inside and upward in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the sliding and tilting mechanism -5- toward the rear until the outer bracket -1- on the operating lever can be removed.

-- Remove the sliding and tilting mechanism farther toward the rear; this will remove the cables with the driver -2 and 3- from the guides.