Glass Trim, Removing And Installing, A6: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Prepare the new glass trim for installation. Refer to NEW GLASS TRIM, PREPARING FOR INSTALLATION .
-- Prepare the body flange for installation. Refer to BODY FLANGE, PREPARING FOR INSTALLATION .
-- Apply the adhesive. Refer to OVERVIEW - ADHESIVE BEADS ON GLASS TRIM, A6 .
-- Insert the new glass trim and align, at the same time pay attention to the following points:
- Glass panel closed.
- The sealing lip on the cover profile -3- of the windshield -1- must contact the glass trim -2- and must point upward -arrow-. For this, attach the sealing lip with adhesive tape to the windshield or place a used cutting wire behind it.
- Check or correct installation dimensions. Refer to GLASS PANEL, ADJUSTING .
Install in reverse order of removal. Note the following:
- Observe minimum curing times. Refer to MINIMUM CURING TIME FOR BONDED SLIDING SUNROOF .
-- Open the glass panel.
-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .