Minimum Curing Time For Bonded Sliding Sunroof

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

For safety reasons, use only two-part adhesive with the identifications listed below when installing the sliding sunroofs.
Only the one-part MS adhesive with the identifications listed below may be used for the side trim.
The vehicle can only be used after the minimum curing time has elapsed.
During the minimum curing time, the vehicle must be resting at room temperature (at least 15 °C (59 °F) (59 °F)) on a level surface.

Component

Adhesive

Minimum Curing Time in Hours

Sunroof frame, glass trim and rear glass panel

Two-Part Window Adhesive Kit :D 004 660 M2

Side Trim, Avant

One-Part MS Assembly Adhesive :D 172 090 A2

24. Refer to ⁽¹⁾.

⁽¹⁾	Do not go through a car wash and do not lift the vehicle with a hoist within the space of three days.