Vehicle, Lifting: Notes
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Using the hoist incorrectly can damage the vehicle.
- Do not exceed the permitted load rating of the hoist.
- Only lift the vehicle at the mounting points shown.
- Position the mounting plate so that it is aligned centrally under the mounting points.
- Maintain distance between the low-lying vehicle components and the hoist.
Procedure :
-- Applies for vehicles with an air suspension ("adaptive air suspension"): before lifting activate vehicle lift mode. Refer to VEHICLE LIFT MODE, ACTIVATING .
-- Applies to the RS models: pull the sill panel reinforcement cover downward -arrow- and remove.
-- Front: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
-- Rear: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
NOTE:
The impressions on the side sill trim panel mark the positions of the mounting points.