Vehicle Lift Mode, Activating

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .

Procedure :

-- Turn on the ignition and activate the MMI.

-- Select the CAR function button.

-- Follow the following menu structure under >>Systems<< :

Adaptive Air Suspension
SETUP

-- Select the function "vehicle lift mode" with the MMI-control knob and set to "ON".

NOTE:

Vehicle lifting mode automatically switches off again when vehicle speed exceeds 15 km/h (9.3 mph).

When the vehicle lift mode is activated for a longer time, the pressure in the suspension strut can lower and thereby also lower the vehicle level. If necessary, quickly start the engine to reactivate the vehicle lift mode.