Diagnostic Procedures, Performing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Procedure :

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Remove the checkmark "Procedures with Guided Fault Finding" .

-- Switch to the "Special Functions" tab and select the following program:

Entire pre-delivery inspection

-- Start the program using Perform test... .

-- Follow and complete the program sequence.

-- Switch to the "Control modules" tab and press the "Guided Fault Finding" button and perform the Guided Fault Finding through to the test plan.

-- The static entries in the DTC memory must be evaluated and corrected using Guided Fault Finding if necessary.

-- Perform diagnostics; a diagnostic log for the pre-delivery inspection will be automatically sent.