Connected Gateway, Replacing Emergency Battery
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Procedure :
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Select the Diagnostic mode and start the diagnosis.
-- Perform the vehicle identification.
-- Set v and press Accept to select "Work with Guided Fault Finding" .
-- Switch to the "Special Functions" tab and select the following program:
- Battery level
-- Start the program using Perform test... .
-- Continue the program sequence.
-- The following actions are derived from the test result:
| Vehicle Diagnostic Tester result: | Action: |
|---|---|
| "Battery OK" | No further action is necessary. |
| "Battery critical" | Replace the battery. Refer to Control Modules . |
| "Faulty" | Replace the battery. Refer to Control Modules . |
NOTE:
A functioning network connection is required for sending the diagnostic log online.