Auxiliary Battery A1

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Applies only to Hybrid vehicles.

Procedure :

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Set v and press Accept to select "Work with Guided Fault Finding" .

-- Switch to the "Special Functions" tab and select the following program:

A - Auxiliary Battery A1, Checking

-- Start the program using Perform test... .

-- Continue the program sequence.

-- The following actions are derived from the test result:

Vehicle Diagnostic Tester result:	Action:
"Battery is OK"	No further action is necessary.
"Battery, Charging"	Charge the battery. Refer to AUXILIARY BATTERY A1, CHARGING .
"Battery no longer meets the delivery quality"	Replace the battery. Refer to AUXILIARY BATTERY A1, REMOVING AND INSTALLING .

NOTE:

A functioning network connection is required for sending the diagnostic log online.