Overview - Final Drive
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 60 Nm +180°
- Always replace after removing
- Quantity: 3
- Stop Washer
- Place on the bonded rubber bushing. Refer to Figure.
- Washer
- Installation position: the bevel (small diameter) faces the subframe
- Bolts
- 60 Nm +180°
- Always replace after removing
- Rear Subframe
- Stop Washers
- Place on the bonded rubber bushing. Refer to Figure.
- Rear Final Drive
- Removing and Installing. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
- Bonded Rubber Bushing, Removing and Installing. Refer to OVERVIEW - ASSEMBLY MOUNTS .