Overview - Driveshaft
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm and 90°
- Always replace after removing
- Driveshaft
- Cannot be separated at the joint.
- Removing and Installing. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm and 90°
- Always replace after removing
- For the front flexible disc on the driveshaft
- Bevel Box
- Front Flexible Disc
- Installation position: the open side of the heat shield faces the transmission
- Bolt
- 50 Nm and 90°
- Always replace after removing
- For the flexible disc to the bevel box
- Double Bolt
- 40 Nm
- Heat Shield
- Bolt
- 20 Nm
- Intermediate Bearing
- Align free of tension
- Bolt
- 50 Nm and 90°
- Always replace after removing
- For the rear flexible disc on the driveshaft
- Rear Final Drive
- Removing and Installing. Refer to OVERVIEW - FINAL DRIVE .
- Flexible Disc with Vibration Damper
- Heat shield faces the driveshaft
- Bolt
- 50 Nm and 90°
- Always replace after removing
- For flexible disc to final drive