Oil Level, Checking
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Pay attention to Refer to SAFETY PRECAUTIONS DURING ROAD TEST WITH TESTING EQUIPMENT .
Special tools and workshop equipment required
Test Requirements
- The oil temperature must be 20 to 40 °C (68 to 104 °F).
- The oil temperature can be reached by driving the vehicle for a while.
- The vehicle must be level.
- Final drive must be in the installation position to check oil level.
-- Read the oil temperature using the Vehicle Diagnostic Tester in Guided Functions .
-- Connect the Vehicle Diagnostic Tester with the vehicle and start the Diagnostic mode.
- Select vehicle test
- Diagnostic-capable systems
- 0022 All-Wheel Drive Control Module J492
- 0022 AWD electronics functions
- 0022 Read the measured value block
- Clutch Temperature
-- Read the oil temperature.
- The oil temperature must be 20 to 40 °C (68 to 104 °F).
Check the Oil Level.
-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the final drive.
-- Remove the oil level inspection plug -2-.
The oil level is correct if the all-wheel drive clutch is filled to the lower edge of the oil filler hole or up to 3 mm below the oil filler hole.
-- Fill the oil for the all-wheel drive clutch if necessary. Refer to Fill the All-Wheel Drive Clutch Oil .
Tightening Specifications: