Brake Pedal, Removing And Installing, LHD: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Both bearing bushings must be located in the brake pedal bearing so that the brake pedal is securely guided into the mounting bracket.
-- Push in the mounting pin -1-.
-- Push on the clamp -2- until it clicks into place on the mounting pin.
-- Attach the brake pedal to the brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .
-- Attach the universal joint to the steering gear. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Install the crash bolster. Refer to CRASH BOLSTER, REMOVING AND INSTALLING .
-- Install the driver side footwell vent. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .
CAUTION:
Faulty brakes increase the risk of an accident.
- Make sure the brakes are working correctly before driving the vehicle for the first time.