Diagnostic Procedures, Performing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Remove the checkmark "Procedures with Guided Fault Finding".

-- Switch to the "Special Functions" tab and select the following program:

Entire pre-delivery inspection

-- Start the program using Perform test... .

-- Follow and complete the program sequence.

-- Switch to the "Control modules" tab and press the"Guided Fault Finding" button and perform the Guided Fault Finding through to the test plan.

-- The static entries in the DTC memory must be evaluated and corrected using Guided Fault Finding if necessary.

-- Perform diagnostics; a diagnostic log for the pre-delivery inspection will be automatically sent.