Battery: Reading Out Condition
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of injury due to unintended engine start on high-voltage vehicles!
- Pay attention to the high-voltage system warning messages:
- For procedures where the ignition must be switched off.
NOTE:
The Full pre-delivery inspection test program may also be performed as an alternative.
Procedure:
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Select the Diagnostic mode and start the diagnosis.
-- Perform the vehicle identification.
-- Set v and press Accept to select "Work with Guided Fault Finding".
-- Switch to the "Special Functions" tab and select the following program:
- A - Battery, Checking
-- Start the program using Perform test... .
-- Continue the program sequence.
-- The following actions are derived from the test result:
| Vehicle Diagnostic Tester result: | Action: |
|---|---|
| "Battery is OK" | No further action is necessary. |
| "Battery, Charging" | Charge the battery. Refer to BATTERY, CHARGING . |
| "Battery no longer meets the delivery quality" | Replace the battery. Refer to BATTERY, REMOVING AND INSTALLING . |
NOTE:
A functioning network connection is required for sending the diagnostic log online.