Battery Transport Mode, Deactivating

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off.

NOTE:

The Full pre-delivery inspection test program may also be performed as part of the pre-delivery inspection.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Switch to the "Special Functions" tab and select the following program:

19 - Activate/deactivate battery transport mode

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

Battery transport mode ensures that the vehicle will be able to start.

When battery transport mode is on, many functions such as the radio do not work or are limited.