Backrest Cover And Cushion, Removing And Installing, Standard/Sport Seat, Excluding A3 Sport Seat: Removing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING .

-- Remove the headrest. Refer to HEADREST, REMOVING AND INSTALLING .

-- Disconnect the wiring harness connectors for the backrest and free up the disconnected wiring harnesses. Refer to WIRE ROUTING, DISCONNECTING AND CONNECTING .

-- Remove the front backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .

-- Detach the molding -1, 2 and 3- at the backrest frame by hand or using the T-Handle Hook:3438 .

Courtesy of AUDI OF AMERICA, LLC

-- Open the backrest cover on the clamping strips starting on the tunnel side.

Courtesy of AUDI OF AMERICA, LLC

-- To do this, press the front side of the cover -1- with the U-shaped profile inward in direction of -arrow A- and remove the rear side of the cover -2- with the flat channel in direction of -arrow B-.

-- If equipped, remove the clips/expanding rivets -arrows- using the Pry Lever:80-200 .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front thorax airbag. Refer to FRONT THORAX AIRBAG WITH IGNITER, REMOVING AND INSTALLING .

-- A3 driver seat: if necessary, remove the center airbag. Refer to Thorax Airbags .

-- Equipped on some models: free up the backrest heating wiring harness.

-- Loosen the cover and cushion from the backrest frame and remove them upward.