Knee Airbag With Igniter, Removing And Installing, Front Passenger Side: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Connect the connector -1- to the airbag igniter -arrow A-.

-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.

Make sure the wires are not pinched.

-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

CAUTION:

Risk of airbag deployment.

Risk of injury.

- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.

-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.

Information for installation: for example, tightening specifications, replacing body parts. Refer to OVERVIEW - KNEE AIRBAG and Refer to OVERVIEW - GLOVE COMPARTMENT .