Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Sling: 2024A

Fig 1: Engine Sling : 2024A
Courtesy of AUDI OF AMERICA, LLC
Engine and Gearbox Bracket: VAS 6095A

Fig 2: Engine And Transmission Holder
Courtesy of AUDI OF AMERICA, LLC
Shop Crane: VAS 6100

Fig 3: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC
Lifting Device: T40123B

Courtesy of AUDI OF AMERICA, LLC

Procedure

The transmission is separated from the engine. Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Remove the intermediate plate. Refer to Fig 4.

Fig 4: Installing Intermediate Plate

GWWN13-10562

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left alignment sleeve from the cylinder block.

-- Engage the Engine Sling: 2024A -item 1- as shown on the engine lifting eye and on the Workshop Crane: VAS 6100 -item 2-.

GWWA10-12635

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of injury from the lifted engine/motor falling.

The possibility for parts of the body to be pinched or crushed increases.

- Secure the mounting hooks and pins on the lifting tackle with a securing pin.

-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.

-- Secure the engine to the Engine and Gearbox Bracket: VAS 6095A -item 1-.

GWWA10-12512

Courtesy of AUDI OF AMERICA, LLC

Assembling

Assemble in the reverse order of removal. Note the following:

-- Insert the left alignment sleeve at the cylinder block.

-- Install the intermediate plate. Refer to Fig 5.

Fig 5: Installing Intermediate Plate

GWWN13-10562

Courtesy of AUDI OF AMERICA, LLC