Engine And Transmission, Separating

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Sling: 2024A

Fig 1: Engine Sling : 2024A
Courtesy of AUDI OF AMERICA, LLC
Lifting Eyebolt: 3368

Fig 2: Identifying Lifting Eyebolt 3368
Courtesy of AUDI OF AMERICA, LLC
Shop Crane: VAS 6100

Fig 3: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC
Engine Bung Set: VAS 6122

Fig 4: Engine Bung Set
Courtesy of AUDI OF AMERICA, LLC
Lifting Device: T40123B

Courtesy of AUDI OF AMERICA, LLC

Procedure

Engine/transmission assembly removed and mounted on Engine/Gearbox Jack - Engine Support: T10359A .

-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .

-- Remove the left air duct pipe. Refer to LEFT AIR DUCT PIPE, REMOVING AND INSTALLING .

-- Remove the nut -arrows- and remove the front bracket from the transmission fluid pan.

Courtesy of AUDI OF AMERICA, LLC

AWD Vehicle:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 and 2- and remove the bevel box bracket.

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Place a cloth underneath to catch leaking coolant.

-- Loosen the hose clamps -arrows-, remove the coolant hoses -1 and 2- from the transmission fluid cooler (example illustration).

-- Seal the open lines and connections with clean plugs from the Engine Bung Set: VAS 6122 .

-- Remove the bolt -1- as well as the nut -2- and press the coolant pipe to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the eye from the Lifting Device: T40123B -item 1- and insert it into the lower threaded hole for the starter bolt all the way.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the Lifting Eyebolt: 3368 -item 6- with two lock nuts -7- on the transmission housing hole.

-- Engage the Engine Sling: 2024A -item 3- as shown on the both eyes and on the Workshop Crane: VAS 6100 -item 4-.

To be aligned to the center of gravity of the transmission, the mounting hook rail with holes must be inserted as shown.

CAUTION:

There is a risk of injury from the lifted engine/motor falling.

The possibility for parts of the body to be pinched or crushed increases.

- Secure the mounting hooks and pins on the lifting tackle with a securing pin.

-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.

-- Remove the bolts -1 to 8- for the transmission/engine connection.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the transmission from the engine.