Steering Column, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the bolts after removing them.
Clean the threaded hole for the bolt on the universal joint with for example a thread tap.

-- Check the steering column for damage. Refer to STEERING COLUMN, CHECKING FOR DAMAGE .

-- If necessary, convert the Electronic Steering Column Lock Control Module -J764-. Refer to Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING .

-- Engage the steering column -2- in the instrument panel crossmember assembly aid -1- at the top and bottom (depending on the version).

Courtesy of AUDI OF AMERICA, LLC

-- Align the steering column to the instrument panel crossmember and position it.

-- Tighten the upper steering column bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the lower steering column bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of accident if the universal joint is installed in the incorrect position.

There is a possible safety risk if there is an absence of traction when steering.

- Note the following the instructions for installation.

-- Mount the flat side on the universal joint -1- onto the flat area of the steering gear -2-.

The opening on the steering gear must exactly align with the round hole for the bolt -arrows-.

Clean the threaded hole (for example, using a thread tap) before installing the new bolt -1- (example illustration).

Courtesy of AUDI OF AMERICA, LLC

-- Check if the universal joint is seated correctly by pulling. Tighten the bolt.

-- Install the footrest. Refer to FOOTREST, REMOVING AND INSTALLING .

-- Install the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

After the installation of the steering column perform the basic setting for the Steering Angle Sensor -G85-. Refer to Steering Angle Sensor -G85- BASIC SETTING .