Overview - Brake Pedal
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Pedal
- The path of the brake pedal must not be shortened by extra floor mats
- BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER
- BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER
- BRAKE PEDAL, REMOVING AND INSTALLING
- Bearing Bushing
- Cannot be replaced
- Note the installation position
- Mounting Pin
- Remove the mounting bracket to remove.
- Do not lubricate or grease. The mounting pin must remain dry
- Bearing Shell
- Installed between the brake booster mount and the brake pedal
- Mount
- For the brake booster ball head
- Bearing Bushing
- Cannot be replaced
- Note the installation position
- Bushing
- Oval
- Bushing
- Round
- Bushings
- Oval
- Bracket
- For Headlamp Range Control Module -J431-
- Headlamp Range Control Module -J431-
- Expanding Clip
- Nut
- Self-locking
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Clip
- For mounting pin
- Replace after removing
- Pedal Assembly/Mounting Bracket
- Pedal Rubber
Mounting Bracket - tightening specification and sequence
-- Tighten the nuts to 25 Nm in the order shown: