LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Wiper/Washer Systems) >> 92 Wiper/Washer Systems >> Windshield Washer System >> Washer Nozzles, Adjusting

Washer Nozzles, Adjusting

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Washer Nozzle, Adjusting

-- Adjusting spray nozzles for windshield washer system:

-- Clean the dirty washer nozzle if the spray field does not match the specifications.

 

Washer Nozzle, Cleaning

 

Washer Nozzle in Hood

-- Remove the spray nozzle. Refer to appropriate Service Information .

 

Continuation

Washer Nozzle in Windshield Wiper Arm

-- Refer to Windshield Wiper, Bringing into Service Position  .

 

-- Slide the service cover -1- toward the rear -arrow- and remove it.

GWWA92-10484Courtesy of AUDI OF AMERICA, LLC
 

-- Free up the washer fluid hoses -3- and -4-.

GWWA92-10488Courtesy of AUDI OF AMERICA, LLC

-- Release the retainers and disconnect the washer fluid hoses -1- and -2- at the connection points.

 

Continuation

CAUTION:

There is a risk of damaging the washer nozzles through improper handling.

- Do not use any objects to clean the washer nozzles.

-- Rinse the washer nozzle with clean water opposite the spray direction.

-- To remove any remaining contaminants, the washer nozzle may only be blown out with compressed air in the opposite direction of the spray direction.

-- If the spray field still does not match the specifications, replace the washer nozzle, respectively the windshield wiper arm.