Input Shaft Seal, Replacing, 0DG: Notes

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Piece - Multiple Use:VW 431

Courtesy of AUDI OF AMERICA, LLC
Puller - Unit Injector:T10055

Fig 1: Identifying Puller T10055
Courtesy of AUDI OF AMERICA, LLC
-2- Puller - Unit Injector - Adapter 2:T10055/2
Thrust washer from Seal Installer - Rear Crankshaft:T10134

Fig 2: Identifying Seal Installer - Rear Crankshaft
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Hollow Shaft:T10380

Fig 3: Identifying Thrust Piece - T10380-
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Shaft Seal:T10432

Fig 4: Identifying Assembly Tool T10432
Courtesy of AUDI OF AMERICA, LLC
-1- Two-Arm Puller:VAS251001

Fig 5: Identifying Special Tools - Kukko 20/10 Puller Set
Courtesy of AUDI OF AMERICA, LLC
Inductive Heater:VAS 6414

Fig 6: Identifying Inductive Heater VAS 6414
Courtesy of AUDI OF AMERICA, LLC
or
Commercially Available Hotplate with Digital Thermometer:VAS 6519

Fig 7: Identifying Digital Thermometer VAS 6519
Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit:SMN372500

Fig 8: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Sealing Grease:G 052 128 A1