Control Module, Removing And Installing: Notes
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The following are integrated in the All-Wheel Drive Control Module -J492- -1- :
- All-Wheel Drive Clutch Actuator -V622-
- All-Wheel Drive Clutch Position Sensor -G969-
Replacing
- If the All-Wheel Drive Control Module -J492- should be replaced, the >>clutch adaptation values<< for the old control module must be read out now using the Vehicle Diagnostic Tester. Refer to ADDITIONAL WORK FOR VEHICLES WITH "quattro ultra" .