Height Adjustment at Striker
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Screw in the adjusting buffer all the way. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .
-- Loosen the clip -2- by removing.
-- Adjust the striker -1- by turning the adjusting screw -3- in direction of -arrows-.
- During the closing test, the hood must fall from the balance position into the latch and engage completely.
-- Adjust the striker height if necessary.
-- Push the clip back on the striker.
-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .