Starter Generator Ribbed Belt, Removing And Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the bolts -arrows- and press the coolant pipe -1- on the lock carrier toward the rear.

Courtesy of AUDI OF AMERICA, LLC

All other procedures are described under: RIBBED BELT, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - COOLANT PIPES, SIDE OF THE VEHICLE
Refer to OVERVIEW - NOISE INSULATION .