Terminal 30A Wire Junction TV3, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the battery. Refer to Battery A, Disconnecting and Connecting .

-- Remove the Terminal 40 Wire Junction -TV66-. Refer to TERMINAL 40 WIRE JUNCTION TV66, REMOVING AND INSTALLING .

-- If installed, disconnect the connector -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainers -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the cover in the sequence -2-, -1-.

-- Remove the wires -1-, -2- and -5- and free them up.

Fig 1: Terminal 30 Wire Junction 2 -TV22 Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4-.

-- Remove the Terminal 30a Wire Junction -TV3- -3- upward.