Brake System Pressure Reservoir -VX70-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Faulty brakes increase the risk of an accident.

- The pressure reservoir must not run empty before reinstalling. Close the connection points with plugs.

-- Pre-bleed the new Brake System Pressure Reservoir -VX70- before installing. Refer to Brake System Pressure Reservoir -VX70-, PRE-BLEEDING .

CAUTION:

Faulty brakes increase the risk of an accident.

- The pressure reservoir must not run empty during further installation.

-- Slide the pressure reservoir onto the retaining pin and secure with clamps.

-- Install the brake line and connect the connector.

-- Remove the Brake Pedal Actuator:V.A.G 1869/2 .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Remove all cloths from the vehicle that were previously placed down.

-- Install the windshield wiper motor. Refer to WINDSHIELD WIPER MOTOR V, REMOVING AND INSTALLING .

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- After replacing the pressure reservoir, complete the "Brake system pressure reservoir, replacing" program using the Vehicle Dianostic Tool.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.