Transmission Output Shaft Seal, Replacing: Installing
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Lightly coat the outer edge of the seal.
-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.
-- Position the seal with the Assembly Device - Sleeve : T40367/1 .
-- Press in the seal all the way using the Assembly Device - Thrust Piece :T40367/2 .
-- Install the all-wheel drive clutch. Refer to ALL-WHEEL DRIVE CLUTCH, REMOVING AND INSTALLING .
-- Install the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .