Spring Element For Bumper Cover Bracket, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
Market-specific:
-- Engage the support -1- with the spring element at the lower bumper carrier -2- and then pivot upward -arrow-.
- The tab -4- in the support must at the same time engage in the edge -3- of the bumper carrier.
Continuation:
-- Rivet the spring element or support with the spring element using the rivets.
-- Push the spring element all the way down and tighten the bolt.
-- Adjust the spring element. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .