Overview - Clutch Housing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Clutch Housing
- Pinion
- Removing and Installing. Refer to PINION, REMOVING AND INSTALLING .
- Disassembling and Assembling. Refer to DRIVE PINION, DISASSEMBLING AND ASSEMBLING .
- Adjusting. Refer to PINION, ADJUSTING .
- Alignment Sleeve
- Quantity: 2
- Parking Lock Gear
- Spur Gear Unit Output Gear
- Circlip
- Replace after removing
- Selecting thickness. Refer to Figure.
- Oil Guide Shell
- Vehicles without self-locking center differential: replace after removal of the roller bearing for the output shaft.
- Inner Output Shaft
- Only on vehicles with self-locking center differential
- With drive wheel for spur gear unit, ball bearing and bearing shell
- Removing and Installing. Refer to Inner Output Shaft Roller Bearing, Removing, Vehicles with Self-Locking Center Differential .
- Disassembling and Assembling. Refer to INNER OUTPUT SHAFT, DISASSEMBLING AND ASSEMBLING, ONLY VEHICLES WITH SELF-LOCKING CENTER DIFFERENTIAL .
- Bolt
- Quantity: 3
- Replace after removing
- 5 Nm + 120°
- Output Shaft Roller Bearing
- Bearing "H"
- Replacing. Refer to Output Shaft Roller Bearing, Replacing, Vehicles without Self-Locking Center Differential .
- Bearing Shell
- Bolts
- Quantity: 2
- 5 Nm + 30°
- Circlip
- Input Shaft Needle Bearing
- Bearing "B"
- Installation position: labeling of the bearing (thicker wall thickness) points to the circlip
- Replacing. Refer to Drive Axle Bearing, Replacing .
- Guide Sleeve
- Installation position: the open side points to the dual clutch
- Seal
- For the input shaft
- Replace after removing
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .