Output Shaft Roller Bearing, Replacing, Vehicles without Self-Locking Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2-.

-- Remove the bearing shell -1-.

-- Break off the tab -arrow- of the oil guide shell using pliers.

• It is necessary to replace the oil guide shell!

Roller Sleeve for the Output Shaft 1, Extend, Vehicles without Self-Locking Center Differential

Fig 1: Roller Sleeve for the Output Shaft -1-, Extend, Vehicles without Self-Locking Center Differential

Courtesy of AUDI OF AMERICA, LLC

2 -

Internal Puller:VAS 251 615 

3 -

Counter Support:VAS 251 623 

4 -

Bearing Installer - Wheel Bearing:3144 

Roller Sleeve for the Output Shaft 1, Driving In, Vehicles without Self-Locking Center Differential

Fig 2: Roller Sleeve for the Output Shaft -1-, Driving In, Vehicles without Self-Locking Center Differential

Courtesy of AUDI OF AMERICA, LLC

3 -

Seal Installer - Gearbox:3295 

Installation position of the roller sleeve: the surrounding groove -arrow- points to the Seal Installer:3295  .

• Beforehand, insert a new oil guide shell -2-.

-- Lay the bearing shell -1- onto the roller sleeve.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -2- to the tightening specification.