Overview - Flywheel And Dual Clutch
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Vehicles with TFSI e (0DK), refer to Clutch .
- Flywheel
- There are different versions depending on the model. Refer to Parts Information for the allocation.
- Removing and Installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH COVER .
- Dual Clutch
- There are different versions depending on the model. Refer to Parts Information for the allocation.
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
- Overview Dual Clutch. Refer to OVERVIEW - DUAL CLUTCH .
- Engaging Bearing
- Pay attention to the installation position
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
- Slave Cylinder
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tighten diagonally to the tightening specification
- Tightening specification 12 Nm + 90°
- Seal
- Replace after removing
- Double Shaft Seal
- Replace after removing
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
- Guide Sleeve
- Pay attention to the installation position
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
- Seal
- Replace after removing
- Seal
- Replace after removing
- Seal
- Replace after removing
- Alignment Sleeve
- Bolt
- Not present depending on the version
- Tighten evenly
- Tightening specification 5 Nm + 30°
- Bolt
- M10 X 15.5
- Tightening specification 60 Nm