LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Turbocharger, Supercharger (4-Cylinder Direct Injection 2.0L 4V TFSI Engine) (DNVB)) >> 21 Turbocharger, Supercharger >> Charge Air System >> Air Duct Pipe, Removing And Installing >> Front Air Duct Pipe, Removing And Installing >> Removing

Front Air Duct Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the air duct from the lock carrier. Refer to AIR DUCT ON LOCK CARRIER, REMOVING AND INSTALLING .

-- Loosen the hose clamps -1 and 2- and remove the air duct hose.

Fig 1: Identifying Clamps
GWWA21-10489Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector for the Charge Air Pressure Sensor -G31-.

Fig 2: Disconnect Charge Air Pressure Sensor Connector
GWWA21-10610Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -2-.

-- Free up the coolant hose on the clip -3-.

-- Remove the bolts -arrows-.

-- Remove the front air duct pipe.

-- Seal the open lines and connections with clean plugs from the Engine Bung Set:VAS 6122  .