Fan Shroud, Removing And Installing, AUDI A3 From My 2021/Q2 From My 2016: Removing
WARNING: This page is about a different car, the 2024 Audi A3 Quattro and 2024 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Loosen the hose clamps -1 and 2- and remove the air duct hose.
-- Seal the open lines and connections with clean plugs from the Engine Bung Set:VAS 6122 .
CAUTION:
There is a risk of injury if the radiator fan turns on by itself.
- Disconnect the connectors.
-- Disconnect the radiator fan connector -1- by sliding the retainer back in the -direction of the arrow A- and pressing the release downward.
-- Press the left and right fan shroud locking tabs at the same time -arrow B- and disengage and remove the fan shroud upward from the radiator.