Rear Lid Drive Unit -VX69- /Rear Lid Drive Unit 2 -VX77-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following.
- Do not hold the rear lid drive unit on the cable when installing.
- The rear lid being completed must be guided by hand, since the rear lid drive unit can destroy the rear lid when the weight is too low.
- The ball sockets on the rear lid drive unit must not strike the ball pins, but rather they must be placed at an angle and be pressed on through a rotational movement.
-- Perform an adaptation. Refer to Rear Lid Drive Unit -VX69- /Rear Lid Drive Unit 2 -VX77-, ADAPTING .