Left Front Level Control System Sensor -G78- /Right Front Level Control System Sensor -G289-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

The level control system sensor lever must point toward vehicle exterior.
The thread on the vehicle level sensor must be installed into the front hole in the transverse link. The tab on the vehicle level sensor bracket must lock into the rear hole to ensure a correct installation position.

-- Vehicles without electronic damping: perform the basic setting of the Matrix LED headlamps after installing. Use the Vehicle Diagnostic Tester.

-- On vehicles with electronic damping perform the basic setting of the electronic damping after installing. Refer to ELECTRONIC DAMPING BASIC SETTING .