Electronic Damping Basic Setting

Adapting the height sensor end stops

Select this basic setting for the following operations:

• The coupling rod on a level control system sensor was separated from the transverse link.
• The threaded connection for a level control system sensor was loosened.
• A level control system sensor was removed and installed.
• A front or rear shock absorber was replaced.

Requirement:

• The vehicle must be raised on the hoist and the wheels are hanging freely, whereby the shock absorbers move into the end stops.

Adapting the Height Sensor Zero Position

Select this basic setting for the following operations:

• The threaded connection for a level control system sensor was loosened.
• A level control system sensor was removed and installed.
• If the Electronic Damping Control Module -J250- was removed or installed.
• A shock absorber was removed and replaced.

Requirements:

• The vehicle must be standing on a level surface.
• The vehicle may not be loaded.

Calibration of Inertial Sensors (Sensors In Control Module)

Select this basic setting for the following operation:

• If the Electronic Damping Control Module -J250- was replaced.

Requirements:

• The vehicle must be standing on a level surface.
• The vehicle may not be loaded.

TIP:

The basic settings can be done individually or together.

Procedure

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Diagnostic-capable systems 
• 0014 - Electronic Damping Control 
• 0014 - Electronic Damping Control, Functions 
• 0014 - Basic Setting 

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.