Electronic Damping Control Module -J250-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- If the Electronic Damping Control Module -J250- is removed and installed, perform the basic setting of the electronic dampening. Refer to ELECTRONIC DAMPING BASIC SETTING .
-- If the Electronic Damping Control Module -J250- is replaced, it must be activated.
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-capable systems
- 0014 - Electronic Damping Control
- 0014 - Electronic Damping Control, Functions
- 0014 - Control Module, Replacing
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.