Lower Control Arm, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the rear control arm into the subframe and swivel it forward.
Install in reverse order of removal. Note the following:
-- Tighten the threaded connections in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Install the subframe. Refer to SUBFRAME, LOWERING .
-- Vehicles without electronic damping: perform the basic setting of the Matrix LED headlamps after installing. Use the => .
-- On vehicles with electronic damping perform the basic setting of the electronic damping after installing. Refer to ELECTRONIC DAMPING BASIC SETTING .
-- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .