Ball Joint, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the self-locking nuts after removing.
-- Vehicles without electronic damping: perform the basic setting of the Matrix LED headlamps after installing. Use the => .
-- On vehicles with electronic damping perform the basic setting of the electronic damping after installing. Refer to ELECTRONIC DAMPING BASIC SETTING .
-- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .