Ribbed Belt, Removing And Installing, Vehicle With Starter Generator: Installing

WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

If the ribbed belt tensioner is not locked the assembly condition must be created next. Refer to RIBBED BELT TENSIONER, ESTABLISHING ASSEMBLY CONDITION .

-- Turn the tensioner slightly counter-clockwise -arrow- and remove the Locking Pin:T10060A .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.