Engine Support, Removing And Installing: Removing

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the oil filter element. Refer to ENGINE OIL .

Audi Q2 from MY 2016:

-- Remove the windshield washer fluid reservoir. Refer to WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .

Continuation for All Vehicles:

Fig 1: Engine Support Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2 and 3- for the pendulum support.

-- Remove the bolts -arrows-.

Fig 2: Exhaust System Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Disconnect the connector -1- for the Oil Pressure Switch -F22- (example illustration).

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Raise the engine using the Engine Support Bridge - Spindle:10-222A/11 until each bolt in the engine support is accessible.

Fig 3: Engine Support - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 2 and 3- and the engine support.