Striker, Adjusting

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Loosen the nuts -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Move the striker -1- into the upper position and push in -direction of the arrow A- or -direction of the arrow B-.

-- Tighten the nuts -2- by hand.

-- Close the rear lid.

Requirement

• The opening on the Rear Lid Lock Unit -VX25- must engage with its rotary latch centered to the striker.

-- Check the adjustment.

Tightening Specifications

• Refer to Overview - Rear Lid  .