ATF Lines, Removing And Installing: Cleaning

• Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Before installing a replacement transmission, always clean out the ATF cooler and ATF lines using compressed air (maximum 10 bar (145 psi)).

-- Place the :SMN372500  under the transmission.

• If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and lines using clean ATF.

Tightening Specifications

• Refer to OVERVIEW - ELECTRIC COOLANT PUMP (2.0L) , OVERVIEW - ELECTRIC COOLANT PUMP (3.0L) .
• Refer to OVERVIEW - NOISE INSULATION .