Overview - Shift Mechanism

WARNING: This page is about a different car, the 2024 Audi A5 Quattro and 2023 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Selector Mechanism in the Vehicle Interior

Fig 1: Exploded View Of Selector Mechanism

Courtesy of AUDI OF AMERICA, LLC

Shift Mechanism
- With the following integrated components:
  - Selector Lever -E313-
  - Selector Lever Position Sensor -G727-
  - Transverse Selector Lever Lock Sensor -G868-
  - Selector Lever Sensor System Control Module -J587-
  - Shift Lock Solenoid -N110-
  - Transverse Selector Lever Lock Motor -V577-
- The components cannot be replaced separately if faulty.
- Removing and Installing. Refer to SHIFT MECHANISM, REMOVING AND INSTALLING .
Selector Lever Transmission Range Display -Y5-
- Removing and installing. Refer to COMPONENT LOCATION OVERVIEW - CENTER CONSOLE LAMPS .
Selector Lever Handle, Upper Section
- Removing and Installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
Bolt
- 3.2 Nm
- Not available separately
Selector Lever Handle, Lower Section
- With the following integrated components:
  - Selector Lever Release Button -E681-
  - Parking Lock Button -E816-
- The components cannot be replaced separately if faulty.
- Removing and Installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
Selector Lever Boot
- Removing and Installing. Refer to SELECTOR LEVER BOOT ON SELECTOR LEVER HANDLE, DISCONNECTING AND ASSEMBLING .
Bolt
- 8 Nm

Gearshift Mechanism on Transmission

Fig 2: Exploded View Of Gearshift Mechanism On Transmission

Courtesy of AUDI OF AMERICA, LLC

Drive Position Sensor -G676-
- Removing and Installing. Refer to Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING .
Shaft
- For the parking lock
Bolt
- 3 Nm +90°
- Replace after removing
- M6 X 30
Parking Lock Solenoid -N486-
- Electro-hydraulic part
- Removing and Installing. Refer to Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING .
Seal
- Replace after removing
Seal
- For the parking lock shaft
- Replacing. Refer to PARKING LOCK SHAFT SEAL, REPLACING .
Spring Pin
Lever
- For the parking lock
- Removing and Installing. Refer to PARKING LOCK SHAFT SEAL, REPLACING .
Cover
- For the parking lock
- With electric wiring harness
Bolt
- 3 Nm +45°
- Replace after removing
- M6 X 14
Bolt
- 8 Nm +60°
- Replace after removing
- M8 X 22
Alignment Pin
- Quantity: 2
Bolt
- 3 Nm +180°
- Replace after removing
- M6 X 55
Bolt
- 3 Nm +90°
- Replace after removing
- M6 X 35