Audi e-tron GT (F8_) from MY 2022

WARNING: This page is about a different variant/trim than selected.

Vehicle	Required Adapters for the Connections to A/C Compressor	Necessary Adapter for the Connections to the Dryer / for the Check Valves and Shut-Off Valves	Miscellaneous
Audi e-tron GT (F8_) from MY 2022	-- Compressor manufacturer "Sanden" (block connections with radial sealing) Low pressure side: Refrigerant Circuits Adapter Set 1 - Adapter 79:VAS 6338/79 High pressure side: Refrigerant Circuits Adapter Set 1 - Adapter 3:VAS 6338/3 Hose:VAS 6338/31 to connect the Refrigerant Circuits Adapter Set 1 - Adapter 3:VAS 6338/3 and the Refrigerant Circuit Adapter:VAS 6338/79 .	Dryer-- Dryer removed and replaced by Refrigerant Circuit Adapter:VAS 6338/76 . Refer to REFRIGERANT CIRCUIT .	-- If necessary, connect the additional Quick-Release Coupling, Low Pressure to the filler hose of the Flushing Device using a fitting Adapter. Order the additional Quick-Release Coupling, Low Pressure and the corresponding Adapter via the respective manufacturer of the A/C Service Station.
		Vehicles with heat pump-- Removed the check valve and replaced by the Adapter:VAS 6338/47-1 from the Refrigerant Circuit Adapter Set:VAS 6338/47 . Refer to CHECK VALVES IN REFRIGERANT CIRCUIT, REMOVING AND INSTALLING .	Open or close the Adapter:VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific repair information).
		Vehicles without heat pump-- Install the Adapter:VAS 6338/47-1 from the Refrigerant Circuit Adapter Set:VAS 6338/47 into the refrigerant line dryer/condenser.	Open or close the Adapter:VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific repair information).

NOTE:

On this vehicle, the refrigerant circuit is flushed in three or four steps (flushing cycles) depending on the vehicle equipment. Refer to Refrigerant Circuit (A/C System Refrigerant Circuit, Cleaning).

The design of the different flushing circuits is described in the vehicle-specific repair information. Refer to Refrigerant Circuit (Cleaning the A/C system refrigerant circuit).

After flushing the dryer must be replaced. Refer to REFRIGERANT CIRCUIT .

Depending on the cause for the flushing procedure, further components must be replaced after flushing. This is described in the vehicle-specific repair information. Refer to Refrigerant Circuit (clean the refrigerant circuit of the A/C system).