Audi Q3 from MY 2017
| Vehicle | Required Adapters for the Connections to A/C Compressor | Adapters Necessary for the Connections to the Reservoir or Receiver/Dryer | Miscellaneous |
|---|---|---|---|
| Audi Q3 (8U_ / 84_) from MY 2017 | -- Compressor manufacturer for the Audi Q3: "Sanden", "Denso", "Delphi/Mahle" or "Zexel / Valeo"
|
Receiver/dryer (different versions)-- No adapter needed, the receiver/dryer remains installed-- Depending on the condenser version, remove the dryer cartridge from the receiver/dryer on the condenser before flushing and then seal the opening again (see note). | Expansion valve remove and installed with the Refrigerant Circuits - Adapter 18:VAS 6338/18 (or a drilled open expansion valve, refer to PRELIMINARY WORK TO CLEAN REFRIGERANT CIRCUIT (FLUSHING WITH REFRIGERANT R1234YF) => .) |
The version of the receiver/dryer on the Audi Q3 will differ depending on the manufacturer of the condenser. On some versions for example the receiver/dryer is integrated in the condenser. The integrated receiver/dryer has a dryer cartridge that is no longer available as a replacement part. Therefore, if there is a complaint regarding a vehicle with a condenser with an integrated receiver/dryer, it may be necessary to replace the entire condenser after correcting the complaint. Refer to the appropriate Electronic Parts Information and Refrigerant Circuit (vehicle-specific repair information).
Condensers with an integrated receiver/dryer or dryer cartridge that cannot be replaced separately or is not available as a replacement part, the condenser must be replaced after flushing (with the dryer cartridge installed). Refer to Refrigerant Circuit (vehicle-specific repair information) and the appropriate Electronic Parts Information.