General Description - Refrigerant Circuit Components: Condenser
- The condenser -A- diverts heat away from the compressed refrigerant gas to the surrounding air.
- This condenses the refrigerant gas to fluid.
Depending on the refrigerant circuit design, the receiver/dryer can be installed (integrated) on the condenser or inside the condenser. Refer to Refrigerant Circuit (vehicle-specific repair information) and the appropriate Electronic Parts Information.
The condenser is available in different versions and can only be differentiated by the part number on the outside. For version -1-, the condenser is divided into two areas "2 way condenser". For version -2-, the condenser is divided into four areas "4 way condenser".
This illustration shows a condenser with the receiver/dryer -C- installed.
The gaseous refrigerant enters at the connection -A- into the condenser. The refrigerant is then cooled inside the condenser and becomes fluid.
The liquid refrigerant collects in the receiver/dryer -C- (with dryer) and flows through the lower cooling area towards the connection -B-.
Depending on the design of the condenser (interior volumes, flow through, etc.), the refrigerant capacity in a refrigerant circuit may vary. For this reason always pay attention to the correct version and allocation of the condenser. Refer to Technical Data (vehicle-specific repair information) and the appropriate Electronic Parts Information.