Front A/C Display Control Head -E87-, REMOVING AND INSTALLING, Q5: Removing
WARNING: This page is about a different variant/trim than selected.
-- Switch off the ignition.
-- Remove the trim -A- with the Front A/C Display Control Head -E87- -B- from the instrument panel. Refer to OVERVIEW - INSTRUMENT PANEL .
-- If multiple identical in construction connectors are installed in this area, mark the connectors -C and D-.
TIP
- Depending on the versions of connectors -C and D- on the Front A/C Display Control Head -E87- this illustration shows the layout on a "Low" A/C system.
-- Loosen the locking mechanism -E- from the connectors -C and D- by pulling -arrow-.
-- Loosen the catch of the connectors -C and D- by pressing -arrow- and remove the connector.
-- Remove the bolts -C-.
-- Release the bracket -A- and loosen the Front A/C Display Control Head -E87- -B- from the trim -D-.